تصميم الصوت : سيدة غاغا "حافة المجد" موالفة باس

Lady Gaga has taken the pop world by storm over the past few years. Learn how to re-create (in Logic or your DAW or synth of choice) the bass synth from her hit single "Edge of Glory".  

في هذا البرنامج التعليمي سريعة ، سنكون يبحث في كيفية استخراج صوت موالفة من ضربة البوب ​​الأخيرة ، سيدة غاغا "حافة المجد" :


في هذه الحالة ، لأنه صوت بسيطة الى حد كبير ، سنكون على استخدام المنطق وفاق 1 softsynth لإعادة موالفة باس الثقيلة الصوت الذي تسمعه في حوالي 1:05 في الأغنية. دعونا نبدأ.


الخطوة 1 -- إعداد مشروع المنطق

فتح المنطق ، والبدء في المشروع مع فارغة جديدة تحتوي على واحد صك برامج فارغة المسار :


فوق والاستمرار على صك EVP88 الافتراضي في الجزء العلوي من الشريط القناة واختيار 01


... لفتح الافتراضي ES النافذة 1 :


الخطوة 2 -- تحليل الصوت

المقبل ، دعونا نستمع إلى صوت : انها قليلا من الصعب جعل بوضوح ، لأن من كل الطبقات الأخرى في الأغنية ، ولكن باس يلعب تلاحظ كلها بسيطة (AEF # - D) باستخدام الصوت مظلم إلى حد ما مع عدم وجود حملات تصفية أو واه - wahs ، على عكس العديد من الأصوات باس موالفة. الهجوم وتسوس هي قصيرة ، ولكن لا صوت نهج التقطه أو طرقي. أقرب الاستماع يكشف عن أن أصوات تتألف من اثنين أو موجات مشرشف مثل سن المنشار اوكتاف مربع على حدة ، مع الترديد طفيفة ، والتي لعبت تلاحظ منبسط ومتساوي ، بحيث لا تكون هناك فجوات فيما بينها.


الخطوة 3 -- إنشاء الصوت

حتى هنا في بلدي وفاق 1 الاسم : (انقر على الصورة أدناه لرؤية نسخة أكبر)


تحقق من الإعدادات عن كثب وبذل قصارى جهدكم لاستنساخ لهم بالضبط كما يمكنك ، وإذا قمت بذلك ، يجب أن نسمع نسخة مقنعة للصوت سيدة غاغا.

دعونا ننظر في بعض هذه الإعدادات بالتفصيل حتى تتمكن من فهم ما يجري في :

  • First, the Sub oscillator is set to a staircase wave, which is a little richer than a sawtooth. 
  • We're using a straight sawtooth for the primary wave, which plays an octave higher than the Sub oscillator. 
  • Note that the Oscillator Mix slider is set so that we hear a bit more of the Sub than the Primary. 
  • Next, Drive is all the way up, to add a little more edge to the sound.


  • The Filter is set to 24 dB, with no Resonance. 
  • The Cutoff to about 11 o'clock or so, to darken up the sound. 
  • Key is set to zero, so the filter stays at the same level throughout the keyboard range, and... 
  • Amplifier is set to Full to give us the maximum level. All the other modulation settings are set to zero, as we don't want any vibrato or tremolo in this sound. 
  • For the same reason, the Mod Envelope is set to zero. 


  • Next, note that the ADSR is set to a short Attack and Release, although neither are set to zero, which would add too much "snap" to the sound. 
  • The Decay is also fairly short, while the Sustain is set to its maximum, so the sound level doesn't drop off after the attack.


  • Below that, Analog is set to 100% to add a little richness to the bass, and 
  • Voices are set to Legato, so to be sure that there are no gaps in the sounds when it's played. 
  • We've also added a little Chorus to add just a little motion to the sound.


النتيجة

هنا ما يبدو مثل :

[الصوت معرف = "7575"]


علما أن لعبت هذه منبسط ومتساوي ، وهذا هو ، هو الذي يعقد سنويا في حين يدون لعبت الملاحظة التالية ، لذلك ليس هناك فجوة بين الأداء والملاحظات ، وأنا ألعب هذه اعتبارا من يوم "A" اوكتاف ان و1 / 3 أدناه C الأوسط .


تحقق من و المنطق ES2 التعليمي مكشوف للحصول على التعامل مع التوليف في المنطق و ايف 8 أصوات للموسيقى الرقص تصميم و تصنيع لايف 8 الرقص الموسيقى الإلكترونية التي Basoski أولاف لأعطيك السبق في تصميم الصوت للعالم من الموسيقى الالكترونية.

Richard Lainhart

More articles by this author

Richard Lainhart is an award-winning composer, filmmaker, and author. His compositions have been performed in the US, Europe Asia, and Australia, and recordings of his music have appeared on the Periodic Music, Vacant Lot, XI Records, Airglow Music, Tobira Records, Infrequency, VICMOD, and ExOvo labels. His animations and short films h... Read More

Discussion

RobertS
Thank you for this great tutorial! Beside the way that it shows that the ES1 still can generate modern sounds its also good to see that the professionals also work with simple sounds and not every patch needs to be overloaded with modulations, fx or anything else.

Want to join the discussion?

Create an account or login to get started!