第1步 - 启动ES1
然后，在I / O部分的通道条督察左下角，单击默认EVP88软件仪器，选择ES1
第2步 - 最多ES1
- Mix is set to Sub only, because the Sub oscillator is the only one of the two that offers white noise.
- The Sub oscillator is set to Noise (the squiggly waveform).
- Drive is set to 0 (zero) to reduce distortion.
- Filter is set to '24dB classic' for the classic swept noise sound.
- The filter's Cutoff is set to about the middle position, but you can adjust that to taste.
- Resonance is also set to about the middle position. The increased Resonance is what gives you a sense of pitch and "whistly-ness" in the final sound. You can also adjust this to taste, but don't set it too high or it will self-resonate and provide too much of a sense of pitch.
- Key is set to the middle position, so that playing further up the keyboard will open the filter up a bit more and let you stack up multiple wind voices in different registers.
- In the bottom section, the Low Frequency Oscillator is set to a smoothed random waveform (the one at the 3 o'clock position), itself derived from white noise. Applying this to the Filter Cutoff will automatically vary the wind's pitch. Rate is set to 0.62 Hz; feel free to adjust this also. Higher frequencies will give you more active wind.
- The slider to the left of the Router is set to the upper 3/4 of its range; this controls the basic amount of the Low Frequency Oscillator that is sent to control the filter's cutoff. In the Router itself, the filter's Cutoff is set as the destination for the Low Frequency Oscillator.
- The slider to the right of the Router is set to the lower 1/6 of its range; this sends a little more of the Low Frequency Oscillator to the filter's cutoff depending on your keyboard's trigger velocity.
- Finally, the ADSR sliders are all set to Long or Full, or nearly so; this will give you long slow attacks and decays for your wind sound.
第3步 - 结论