Criação de Vento FX: Filtragem de ruído em Lógica Utilizando o ES1

In this Quick Tutorial, we'll look at how to create a classic analog synthesis sound — the sound of whistling wind — using Logic's ES1 synth.  

Neste rápido tutorial, veremos como criar um som tipo síntese analógica o som do vento assobiando usando Logic synth ES1.


Passo 1 - Lançamento ES1

Comece abrindo Logic e escolhendo Arquivo


Então, na seção I / O da faixa de canal na parte inferior esquerda do Inspector, clique e segure sobre o Instrumento de Software padrão EVP88 e escolha ES1


Finalmente, dê um duplo clique no botão ES1 azul para abrir a janela ES1:


Passo 2 - Configurar ES1

Configurar o ES1, como mostrado na imagem abaixo:


Aqui está uma listagem de todas as definições essenciais, da esquerda para a direita e de cima para baixo, eo que eles significam:

  • Mix is set to Sub only, because the Sub oscillator is the only one of the two that offers white noise. 
  • The Sub oscillator is set to Noise (the squiggly waveform). 
  • Drive is set to 0 (zero) to reduce distortion. 
  • Filter is set to '24dB classic' for the classic swept noise sound. 
  • The filter's Cutoff is set to about the middle position, but you can adjust that to taste. 
  • Resonance is also set to about the middle position. The increased Resonance is what gives you a sense of pitch and "whistly-ness" in the final sound. You can also adjust this to taste, but don't set it too high or it will self-resonate and provide too much of a sense of pitch. 
  • Key is set to the middle position, so that playing further up the keyboard will open the filter up a bit more and let you stack up multiple wind voices in different registers. 
  • In the bottom section, the Low Frequency Oscillator is set to a smoothed random waveform (the one at the 3 o'clock position), itself derived from white noise. Applying this to the Filter Cutoff will automatically vary the wind's pitch. Rate is set to 0.62 Hz; feel free to adjust this also. Higher frequencies will give you more active wind.
  • The slider to the left of the Router is set to the upper 3/4 of its range; this controls the basic amount of the Low Frequency Oscillator that is sent to control the filter's cutoff. In the Router itself, the filter's Cutoff is set as the destination for the Low Frequency Oscillator. 
  • The slider to the right of the Router is set to the lower 1/6 of its range; this sends a little more of the Low Frequency Oscillator to the filter's cutoff depending on your keyboard's trigger velocity.
  • Finally, the ADSR sliders are all set to Long or Full, or nearly so; this will give you long slow attacks and decays for your wind sound.


Etapa 3 - Conclusão

Agora jogar um par de notas no seu teclado MIDI no meio de sua escala, e você deve ouvir um som de vento convincente inverno. Tente adicionar um reverb longo de Designer espaço para um som ainda ghostlier:

[Audio id = "6749"]


E, como sempre, experimentar e se divertir no Logic !



Richard Lainhart

More articles by this author

Richard Lainhart is an award-winning composer, filmmaker, and author. His compositions have been performed in the US, Europe Asia, and Australia, and recordings of his music have appeared on the Periodic Music, Vacant Lot, XI Records, Airglow Music, Tobira Records, Infrequency, VICMOD, and ExOvo labels. His animations and short films h... Read More

Discussion

Want to join the discussion?

Create an account or login to get started!