Creazione Vento FX: Filtraggio del rumore in Logica Utilizzando il ES1

In this Quick Tutorial, we'll look at how to create a classic analog synthesis sound — the sound of whistling wind — using Logic's ES1 synth.  

In questo breve tutorial, vedremo come creare un suono classico sintesi analogica il suono del fischio del vento utilizzando Logic synth ES1.


Fase 1 - Avvio ES1

Inizio con l'apertura di Logica e scegliendo File


Quindi, nella sezione I / O della striscia di canale in basso a sinistra del Impostazioni, fare clic e tenere premuto lo strumento predefinito EVP88 Software e scegliere ES1


Infine, fare doppio clic sul pulsante blu ES1 per aprire la finestra ES1:


Fase 2 - Set Up ES1

Configurare il ES1, come mostrato nello screenshot qui sotto:


Ecco una lista di tutte le impostazioni essenziali, da sinistra a destra e dall'alto in basso, e il loro significato:

  • Mix is set to Sub only, because the Sub oscillator is the only one of the two that offers white noise. 
  • The Sub oscillator is set to Noise (the squiggly waveform). 
  • Drive is set to 0 (zero) to reduce distortion. 
  • Filter is set to '24dB classic' for the classic swept noise sound. 
  • The filter's Cutoff is set to about the middle position, but you can adjust that to taste. 
  • Resonance is also set to about the middle position. The increased Resonance is what gives you a sense of pitch and "whistly-ness" in the final sound. You can also adjust this to taste, but don't set it too high or it will self-resonate and provide too much of a sense of pitch. 
  • Key is set to the middle position, so that playing further up the keyboard will open the filter up a bit more and let you stack up multiple wind voices in different registers. 
  • In the bottom section, the Low Frequency Oscillator is set to a smoothed random waveform (the one at the 3 o'clock position), itself derived from white noise. Applying this to the Filter Cutoff will automatically vary the wind's pitch. Rate is set to 0.62 Hz; feel free to adjust this also. Higher frequencies will give you more active wind.
  • The slider to the left of the Router is set to the upper 3/4 of its range; this controls the basic amount of the Low Frequency Oscillator that is sent to control the filter's cutoff. In the Router itself, the filter's Cutoff is set as the destination for the Low Frequency Oscillator. 
  • The slider to the right of the Router is set to the lower 1/6 of its range; this sends a little more of the Low Frequency Oscillator to the filter's cutoff depending on your keyboard's trigger velocity.
  • Finally, the ADSR sliders are all set to Long or Full, or nearly so; this will give you long slow attacks and decays for your wind sound.


Fase 3 - Conclusione

Ora giocare un paio di note sulla tastiera MIDI al centro della sua gamma, e si dovrebbe sentire un suono convincente vento invernale. Prova ad aggiungere un riverbero lungo da Space Designer per un suono ancora ghostlier:

[Audio id = "6749"]


E, come sempre, sperimentare e divertirsi in Logic !



Richard Lainhart

More articles by this author

Richard Lainhart is an award-winning composer, filmmaker, and author. His compositions have been performed in the US, Europe Asia, and Australia, and recordings of his music have appeared on the Periodic Music, Vacant Lot, XI Records, Airglow Music, Tobira Records, Infrequency, VICMOD, and ExOvo labels. His animations and short films h... Read More

Discussion

Want to join the discussion?

Create an account or login to get started!