Выбор и настройка студийных мониторов, конечно, один из наиболее важных аспектов проектирования хорошую записи / смешения пространство. Каждое решение сделано во время процесса записи
Есть много подходит
1. Avoid the Hype
Потребительские колонки часто разработан, чтобы сделать все играли через них звучат так хорошо, как это возможно. Тем не менее, это не цель для студийных мониторов. Целью мониторинга является не способствовать последовательно приятный опыт прослушивания, но раскрыть правду о звуке записи или смеси
Звук многих потребительских динамиков часто
К счастью, большинство ораторов, продаваемые как студийные мониторы стрелять на (более желательно) нейтрального баланса, способны обеспечить надлежащий ссылку для принятия решений. Тем не менее, я до сих пор иногда попадаются люди, которые применяются самостоятельно
Но эти элементы управления там, чтобы не добавить стук и шипение, они
2. Avoid the walls
Большинство людей, когда заметил, что спикер любого размера помещается в стену, его
Большинство мониторов поставляются с рекомендацией для размещения, и многие включают регулируемый низким уровнем конца ответ, в соответствии колонки к размещению
Но эти элементы управления бас выиграл
3. Avoid Asymmetry
Даже если вам избежать резервного мониторы к стене, отражения от стен помещения будет по-прежнему влиять на звук. В идеале, вам
Таким образом, какие-либо последствия отражений должна быть похожа
4. Avoid poor angles
Позиционирование мониторы или слишком близко или слишком далеко друг от друга могут испортить ваши стерео панорамирования решения. Выступающие, которые слишком широко расставленные может обеспечить стерео изображение с отверстием-в-середине. Это может привести к вам слишком много сгустков элементов смеси недалеко от центра, в результате чего в смеси, что Безразлично
Оптимальный угол для стерео мониторов ~ 60
Если ты
5. Avoid reflections
Вы надеваете
Хотя вы не можете быть в состоянии полностью избежать все такие размышления (как пытались с некоторыми конструкций высокого класса студии), вы можете попробовать, чтобы свести их к минимуму. Избегайте размещения Светоотражающие элементы на высоте уха / громкоговорителя в-между динамиками и слушателем. Многие громкоговорители имеют узкую дисперсию в вертикальной плоскости
6. Avoid excessive levels
Есть ряд причин, почему постоянно мониторинга на слишком громкий уровень не хорошая идея. Там
Многие люди знакомы с кривыми Флетчера-Мансон, которые описывают аспект человеческого слуха.
Наши уши более чувствительны к высокой конца и, особенно, в нижнем конце, при более высоких уровнях громкости
Большинство инженеров рекомендуем работать / смешивания при последовательных средних уровнях вокруг 83
7. Avoid too much sub
Еще один дополнительный совет .. Если вы чувствуете, что вам нужно больше низы от меньше (
При настройке югу, когда это возможно, использовать SPL измеритель и тест-сигналов (т / шум) для дозвона аа суб уровень, который соответствует уровень низких частот основных динамиков (на октаву или две выше), страхование, поскольку даже ( квартира) ответ как можно все, вплоть до пределов суб
И что
Вы хотите узнать больше о акустике ли? Смотрите эту прекрасную видео-учебник по Джо Альбано ЗДЕСЬ .
Discussion
Two questions on point 7 ... background first ... SPL'd my 2.1 setup using a couple different methods/mics and found (not unexpectedly) that the further I went below the sub crossover frequency (120HZ) the greater the "pump" it provided relative to the 5" satellites as I toggled the sub on/off. So I chose to equalize the setup dBs at that crossover point.
Questions:
1) At what frequency should I attempt to "match" the dBs between the sub on/off states?
2) What criteria should be considered when setting a crossover frequency for a 2.1 setup that has a variable crossover setting? Room? Genre? Mixing vs Mastering vs ... etc.
Pre-thanks for your feedback!
Re (1), sounds like your approach—match sub to satellites at the crossover point—is solid.. Ideally, you want the sub to pick up seamlessly from the satellites at a point where the smaller speakers are still more or less flat, just before or just as they start to roll off.. As to what the best crossover frequency will be (2), I'd say if you want the most neutral response (always the goal!), then it'll depend more on the size and low-frequency extension of the satellites than on genre or application.. I'd say 120 Hz is near the top of the range—I prefer around 80 Hz or so, but if the satellites are on the smaller side (
Hi Koolmeme..
Re (1), sounds like your approach—match sub to satellites at the crossover point—is solid.. Ideally, you want the sub to pick up seamlessly from the satellites at a point where the smaller speakers are still more or less flat, just before or just as they start to roll off.. As to what the best crossover frequency will be (2), I'd say if you want the most neutral response (always the goal!), then it'll depend more on the size and low-frequency extension of the satellites than on genre or application.. I'd say 120 Hz is near the top of the range—I prefer around 80 Hz or so, but if the satellites are on the smaller side (
I think the most likely way a 5" speaker would exhibit too much bass is if it's up against a room boundary (wall, floor, or worst of all, corner). If that's the case, that'd be the first thing I'd try, moving them a couple of feet away from walls and floor. If they were sitting on a resonant object (something hollow, for example) that could also over-emphasize bass. Of course you'll want to check that no tone controls are boosting the low end unintentionally. Any "Loudness" buttons should be off -- those are intended to compensate for quiet listening levels by strongly boosting bass, but they're notorious for overdoing it, and they should never be switched on for normal-level monitoring. And I assume you've checked the monitors with various commercial recordings as well as your own mixes. Hopefully one of these might be a contributing factor to an overly-bassy response, and addressing that will restore a more even balance.
Cheers,
Joe
Cheers,
Joe
I don't understand the Fig. 6 diagram/image. I don't see how the monitors are positioned differently to do away with those reflections shown in the top portion of the image?
I also like how in your diagrams, there is no computer shown. How great!
Some monitors -- if they have different horizontal/vertical dispersion patterns -- even provide an option to unscrew the tweeters and rotate them 90°, to allow for either horizontal or vertical positioning with the appropriate dispersion characteristics at the critical higher frequencies.
Cheers,
Joe
First off, an anechoic chamber is not an "ideal room" -- at least not for listening to or mixing music.. And the 60° angle recommendation is not about room modes, it's about perception of the stereo soundfield.
> You can't just apply some theoretically ideal angle and get it right..
Whatever "get it right" means, the article doesn't suggest that a 60° angle is a panacea for any of the myriad issues that may relate to reflections or room modes -- it's a standard recommendation intended as a general guideline for novice engineers who might be inclined to position the monitors in a less-than-ideal layout that might not work as well for them.
> ..having your speakers too close won't mess with your stereo field...
Again, the article doesn't suggest that closely-placed monitors will "mess with your stereo field" -- it suggests that it could mess with an inexperienced mixer's panning decisions. (Overly-wide positioning *can* affect the perceived stereo image, unless you sit really still while mixing)..
> ..does that happen for you with headphones?
If "that" means affect panning decisions, then yes, it certainly can with inexperienced mixers.
It sounds like you may have your speakers positioned differently than the article recommends (and perhaps are sensitive about perceived criticism of that choice?) -- if that’s the case, and it works for you, then it’s all good. But the standard 60° angle recommendation is still good advice for others.
Cheers,
Joe
Regardless of the speaker design or port location, the speakers are still subject to the effects of room modes if mounted up against a wall. If they have a switch on the back to match their low-end response for different placements, the half-space position would theoretically modify the bass response to be more suitable for wall placement, but you should still get more even bass response with such a switch in the full-space mode, and the speakers mounted a couple of feet or so from any room boundaries.
Cheers,
Joe
Thanks
Want to join the discussion?
Create an account or login to get started!