انتخاب و راه اندازی مانیتور استودیو است، البته، یکی از مهم ترین جنبه های طراحی یک ضبط خوب / مخلوط کردن فضا. هر تصمیم گیری های انجام شده در طول فرایند ضبط
مقدار زیادی از مناسب وجود دارد
1. Avoid the Hype
سخنرانان مصرف کننده اغلب طراحی شده تا همه چیز را از طریق آنها بازی صدا به خوبی به عنوان امکان پذیر است. با این حال، این است که گل مانیتور استودیو نیست. هدف از نظارت است برای ترویج یک تجربه گوش دادن به طور مداوم لذت بخش نیست، اما به آشکار کردن حقیقت درباره صدای ضبط یا مخلوط
صدای بسیاری از سخنرانان مصرف کننده است که اغلب
خوشبختانه، اغلب بلندگوهای فروخته شده به عنوان مانیتور استودیو برای (مطلوب تر) تعادل خنثی ساقه، قادر به فراهم آوردن مرجع مناسب برای تصمیم گیری. با این حال من هنوز هم گاهی اوقات در سراسر افرادی که خود را اعمال می آیند
اما این کنترل ها وجود دارد به اضافه نمی ضربت و صدای هیس کردن، آنها
2. Avoid the walls
اکثر مردم متوجه شده اند که هنگامی که یک سخنران به هر اندازه در برابر یک دیوار قرار داده شده، آن
اکثر ناظران با توصیه برای قرار دادن آمده، و بسیاری از شامل قابل تنظیم پاسخ کم پایان، برای مطابقت با سخنرانان به قرار دادن
اما این کنترل باس را به دست آورد
3. Avoid Asymmetry
حتی اگر شما اجتناب از حمایت از مانیتور در برابر دیوار، بازتاب از مرزهای اتاق هنوز هم صدای تاثیر می گذارد. در حالت ایده آل، شما
به این ترتیب، هر گونه عوارض از بازتاب باید شبیه
4. Avoid poor angles
موقعیت مانیتور یا بیش از حد به هم نزدیک یا خیلی دور از هم می توانید میکشید تا تصمیم گیری سوژه متحرک از روبرو استریو خود را. بلندگو که بیش از حد به طور گسترده ای فاصله ممکن است یک تصویر استریو با یک سوراخ در وسط فراهم می کند. این می تواند شما را به دسته بیش از حد بسیاری از عناصر ترکیب در نزدیکی مرکز منجر به ترکیبی که نشانی
زاویه ایده آل برای مانیتور استریو است ~ 60
اگر شما
5. Avoid reflections
شما نمی
در حالی که شما ممکن است قادر به طور کامل اجتناب از همه این بازتاب (به عنوان با طرح های بالا پایان استودیو خاص اقدام)، شما می توانید سعی کنید آنها را به حداقل برساند. اجتناب از قرار دادن عناصر بازتابنده در گوش ارتفاع / سخنران در بین سخنرانان و شنونده است. بسیاری از سخنرانان یک پراکندگی باریک تر در صفحه عمودی
6. Avoid excessive levels
تعدادی از دلایلی که به طور مداوم نظارت بر در وجود دارد بیش از حد بلند است یک سطح یک ایده خوب نیست. آنجا
بسیاری از مردم با منحنی فلچر-Munson، که از جنبه های شنوایی انسان توصیف آشنا هستند.
گوش ما حساسیت بیشتری نسبت به پایان بالا هستند و، به ویژه، برای پایان دادن به پایین، در سطوح بالاتر گوش دادن
اکثر مهندسان توصیه کار / مخلوط کردن در سطوح سازگار به طور متوسط حدود 83
7. Avoid too much sub
یک پیشنهاد فوق العاده تر .. اگر شما احساس می کنید نیاز بیشتری کم پایان از کوچکتر (
زمانی که راه اندازی زیر، در صورت امکان استفاده از یک متر SPL و سیگنال های آزمون (تن / سر و صدا) به شماره گیری نمایید تا AA سطح زیر که منطبق بر سطح پایین ترین فرکانس از سخنرانان اصلی (یک اکتاو یا دو بالاتر)، بیمه به عنوان حتی ( تخت) پاسخ که ممکن است تمام راه را به محدودیت های زیر
و آن
آیا شما می خواهید برای کسب اطلاعات بیشتر در مورد آکوستیک؟ سازمان دیده بان این ویدیو آموزش عالی توسط جو و Albano اینجا .
Discussion
Two questions on point 7 ... background first ... SPL'd my 2.1 setup using a couple different methods/mics and found (not unexpectedly) that the further I went below the sub crossover frequency (120HZ) the greater the "pump" it provided relative to the 5" satellites as I toggled the sub on/off. So I chose to equalize the setup dBs at that crossover point.
Questions:
1) At what frequency should I attempt to "match" the dBs between the sub on/off states?
2) What criteria should be considered when setting a crossover frequency for a 2.1 setup that has a variable crossover setting? Room? Genre? Mixing vs Mastering vs ... etc.
Pre-thanks for your feedback!
Re (1), sounds like your approach—match sub to satellites at the crossover point—is solid.. Ideally, you want the sub to pick up seamlessly from the satellites at a point where the smaller speakers are still more or less flat, just before or just as they start to roll off.. As to what the best crossover frequency will be (2), I'd say if you want the most neutral response (always the goal!), then it'll depend more on the size and low-frequency extension of the satellites than on genre or application.. I'd say 120 Hz is near the top of the range—I prefer around 80 Hz or so, but if the satellites are on the smaller side (
Hi Koolmeme..
Re (1), sounds like your approach—match sub to satellites at the crossover point—is solid.. Ideally, you want the sub to pick up seamlessly from the satellites at a point where the smaller speakers are still more or less flat, just before or just as they start to roll off.. As to what the best crossover frequency will be (2), I'd say if you want the most neutral response (always the goal!), then it'll depend more on the size and low-frequency extension of the satellites than on genre or application.. I'd say 120 Hz is near the top of the range—I prefer around 80 Hz or so, but if the satellites are on the smaller side (
I think the most likely way a 5" speaker would exhibit too much bass is if it's up against a room boundary (wall, floor, or worst of all, corner). If that's the case, that'd be the first thing I'd try, moving them a couple of feet away from walls and floor. If they were sitting on a resonant object (something hollow, for example) that could also over-emphasize bass. Of course you'll want to check that no tone controls are boosting the low end unintentionally. Any "Loudness" buttons should be off -- those are intended to compensate for quiet listening levels by strongly boosting bass, but they're notorious for overdoing it, and they should never be switched on for normal-level monitoring. And I assume you've checked the monitors with various commercial recordings as well as your own mixes. Hopefully one of these might be a contributing factor to an overly-bassy response, and addressing that will restore a more even balance.
Cheers,
Joe
Cheers,
Joe
I don't understand the Fig. 6 diagram/image. I don't see how the monitors are positioned differently to do away with those reflections shown in the top portion of the image?
I also like how in your diagrams, there is no computer shown. How great!
Some monitors -- if they have different horizontal/vertical dispersion patterns -- even provide an option to unscrew the tweeters and rotate them 90°, to allow for either horizontal or vertical positioning with the appropriate dispersion characteristics at the critical higher frequencies.
Cheers,
Joe
First off, an anechoic chamber is not an "ideal room" -- at least not for listening to or mixing music.. And the 60° angle recommendation is not about room modes, it's about perception of the stereo soundfield.
> You can't just apply some theoretically ideal angle and get it right..
Whatever "get it right" means, the article doesn't suggest that a 60° angle is a panacea for any of the myriad issues that may relate to reflections or room modes -- it's a standard recommendation intended as a general guideline for novice engineers who might be inclined to position the monitors in a less-than-ideal layout that might not work as well for them.
> ..having your speakers too close won't mess with your stereo field...
Again, the article doesn't suggest that closely-placed monitors will "mess with your stereo field" -- it suggests that it could mess with an inexperienced mixer's panning decisions. (Overly-wide positioning *can* affect the perceived stereo image, unless you sit really still while mixing)..
> ..does that happen for you with headphones?
If "that" means affect panning decisions, then yes, it certainly can with inexperienced mixers.
It sounds like you may have your speakers positioned differently than the article recommends (and perhaps are sensitive about perceived criticism of that choice?) -- if that’s the case, and it works for you, then it’s all good. But the standard 60° angle recommendation is still good advice for others.
Cheers,
Joe
Regardless of the speaker design or port location, the speakers are still subject to the effects of room modes if mounted up against a wall. If they have a switch on the back to match their low-end response for different placements, the half-space position would theoretically modify the bass response to be more suitable for wall placement, but you should still get more even bass response with such a switch in the full-space mode, and the speakers mounted a couple of feet or so from any room boundaries.
Cheers,
Joe
Thanks
Want to join the discussion?
Create an account or login to get started!